Skip navigation
1909 Views 0 Replies Latest reply: Jun 3, 2011 9:45 AM by moss2k10 RSS
moss2k10 Rank: White Belt 24 posts since
Dec 13, 2010
Currently Being Moderated

Jun 3, 2011 9:45 AM

How to set RRD type in data point config to show current load on a interface?

I've succesfully configured some new graphs to show VPN throughput, but after doing some tests I found out that used OIDs are pointing sum of bytes/packets from/to a tunnel interface, not current load on them.

 

 

Does anyone know how to set RRD types in data point configuration to show only current load instead of a sum of all received/sent bytes/packets?

More Like This

  • Retrieving data ...

Legend

  • Correct Answers - 4 points
  • Helpful Answers - 2 points